Penjagaan Autogate Dan Masalah Yang Sering Dihadapi Pelanggan Kami..

                     Maintenance

•   All maintenance should be carried out by qualified personnel.

•   Clean and lubricate any moving components.

•   In case of rust, use some grease on it.

•   Ensure that the slider gate is always well balanced.

•    Ensure there are not binding / sticking of the gates which can falsely trigger the obstruction sensing unit.

•    Regularly test the slider gate motor to ensure that the obstruction sensor unit is operating properly.

Problem	Possible cause	Solution
Handset(remote control) doesn’t work or has too short-a range	Handset battery may be flat Handset may not be coded to the Receiver Board Receiver antenna not be fully extended Radio interference may be affecting your Receiver	Replace BatteryCode Handset (see Section 15) Extend Aerial Remove anypossible external interference e.g. Baby Monitor
The gate doesn’t open or close	Power source may not be connected. Back up battery may be exhausted after prolong power failure	Ensure the transformer is connected to the circuited board Ensure the battery is connected to the circuited board
The gate re-opens or stops during operation	Sensitivity may be set too light (Motor may need more torque) Gate may be obstructed Photoelectric cells- Safety Beams( where fitted) may be dirty	Increase motor torque Check for obstruction Clean and check PE cells
The gate auto opens rather then auto closes Open green led is on, but gate is close Close red led is on but gate is open	Motor & Limit switch may be wired I reverse	Change motor on the circuit board & re-adjust Limit switch
The motor spins but the gate doesn’t open	The manual release may not be engaged.	Ensure the manual release are properly engaged and tighten onto the gear

•   Spare parts can be purchased directly from us.